Furniture Information

Melteca Decorated Board is a versatile pre-decorated panel with a durable melamine surface on both sides. For interior use only, Melteca Decorated Board is available in a range of decors, on a choice of substrates, sizes &
thicknesses.
Never use any of the following Abrasive cleaners:
Jif, Vim, Ajax, Chemico, Brasso, Oven Cleaners, neat Janola, wire wool, scourer pads, sandpaper.

Cleaning
• Wash down with warm water with a small amount of detergent. For best results use streak free glass cleaner with a soft cloth.
• For textured finishes (stipple, wood grain, etc) the periodic use of a soft brush may be necessary for the removal of dirt build-ups and residues left by some spray-on cleaners.

Spillages
• Hair rinse, Janola (neat), Harpic, oven cleaners – wash with hot soapy water then wipe dry.
• Fabric Dye – wash with cold water, then wipe dry. Then apply methylated spirits, and wipe dry.
• Battery acid, Hydrogen Peroxide, Glue Hardners – wash with cold water, then wipe dry.
• Hair Dye – wash with methylated spirits, then wipe dry.
• Leather Dye – wash with methylated spirits, then wipe dry. Follow with mineral turpentine wash and wipe dry.

Stain and Mark Removal
• Stubborn marks or stains – apply Handy Andy or diluted Janola (1 part to 3 parts water), then wipe down with a warm damp cloth.
• Smearing, finger marks, marking from cold or hot dishes, stickiness – apply 1 or 2 applications of acetone (available at pharmacies) and wipe over with dry cloth.
• Newsprint – use methylated spirits or mineral turpentine
• Rust – use vinegar or lemon juice
• Pencil – use water and a damp cloth
• Felt pen or dry marker - use methylated spirits or acetone
• Paint – use acetone or Duco Lacquer thinners (from a paint shop)
• Glue – contact type – use Ados Solvent N (from a paint shop)
Once again with any of the above use streak free glass cleaner to remove any residues.

Courtesy of Melteca.co.nz

1. For this we have the rectangle surface of Width (Left to Right) x Depth (Front to Back) x Height (Floor to Desk top Surface).
2. For quoting or writing purposes we write this as the following.

• 1600mmW x 700mmD x 725mmH.

1. We have two surface sides being a left and right and quite often they are different.
2. We always determine the 'Left or Right' by making the viewing point from where the user sits and operates the corner work station from - the inside corner.
3. We apply the following leaving the height till last.

• Width (Left to Right of Left Back Edge) x Depth (Front to Back of Left Edge) - Width (Left to Right of Right Back Edge) x Depth (Front to Back of Right Edge )Height (Floor to Desk top Surface)
• L-Desk the following example.
• 1200mmW x 600mmD Left - 1800mmW x 600mmD Right - 710mmH
• We refer to this Desk as a  'Right Hand Corner Station' because the longer side is on the left.
  
• Graphic as an example.